Correct installation of High Pressure Jack Hose is the key to ensure the safe and efficient operation of equipment. Incorrect installation may cause safety accidents. The following three aspects introduce standard installation methods.
1. Preparation before installation
Select an appropriate High Pressure Jack Hose. The working pressure and interface size of different jacks are different. You need to refer to the instructions to select the matching two-layer steel wire hose to ensure system matching. Carefully check the appearance of the High Pressure Jack Hose to avoid using scratched, flattened or cracked hoses. At the same time, clean the oil and impurities at the jack interface to prevent foreign matter from entering the system.
2. Specific steps for installation
When connecting the hose and jack interface, ensure that the interface is aligned to avoid tilting or misalignment. Insert the hose connector smoothly into the jack interface and tighten it with the matching nut according to the specified torque. Note that the torque should be moderate. Too tight will damage the interface, and too loose will cause oil leakage.
3. Inspection after installation
After installation, check whether the joint is firm. Run the jack without load and check whether the hose is leaking or twisting. If any abnormality is found, stop the operation immediately and use it after troubleshooting.
Strictly following these steps can not only extend the service life of the equipment but also ensure the safety of the operation.
